“Flow Mat is a stitched sandwich composed of glass fiber reinforced material made of a draining non-woven synthetic core of PP(resin flow layer) with both sides of chopped glass fibers (CSM) mechanically stitched together.”

In particular, the resin flows horizontally and slowly through into the PP core layer, Secondly, the injection machine impregnates outer reinforcements. All these two kinds of process impregnation save a significant amount of time and labor, Advantages for this PP flow layer enhancer leads to horizontal injection throughout the full width of the component to experience extreme acceleration.

This flow mat makes an optimized resin flow zone of the polypropylene (PP) layer. This leads to resin four times faster flow speed, upon five times faster with our special high-flow variant layer.

Perfect drapability

Flow Mat is easily deformed in complex mold shapes, also applies good surface finish properties through a perfect flow layer. The better optimum choice for close mold processes such as RTM, RTM light, infusion, etc.

The resin flow rapid.

The flow layer has a 25 % faster flow rate compared with the mat without a flow layer. The High-Flow version saves time during large parts when the time for resin transfer is limited

Spotlight: Flow mat are available in combination with other materials as product variants.

The layer of reinforcements can be freely adapted and comprise optionally of one or two chopped strand layers. And, the flow layer is selectable by PP or other material: CFM, Flow Mesh. Besides: multiaxial technology is integrated into the flow mat as a combination max product, which means that the sandwich complex is additionally reinforced with multiaxial interlaid complexes.

Flow mat and combination product not only apply time savings in terms of the resin flow speed but also make mold filling time reduced in wide margin again.

To get a bright, smooth product surface appearance for the finished component, the Flow mat could supply an additional non-woven covering like PAN Surfacing Veil, Polyester Surfacing Veil which covers fiber print pave directly on mold cavity or together with Gelcoat. On the best, Dymriton can also produce customer-specific material in our special technology.

A flexible range of applications and individually adaptable width and type of flow layer material can be individually adapted, depending on your requirements. Both sides chopped strand fiber layer type is selectable freely.

Available in combination with other Dymriton solutions All in one: Reinforced with a demotion combination mat it is possible to fill the mold in just a single stage. The remarkable mechanical characteristics are achieved through the incorporation of multiaxial interlaid complexes.

If interesting, contact Dymriton to get Flow Mat Sample!